P0623
Generator Lamp Control Circuit
P0623 concerns the control of the battery warning lamp by a module's output driver, not the alternator itself. Traditionally the regulator switches the lamp through terminal L; where a module switches it instead – GM's Saab 9-4X turns the lamp on 15 s after a charging code – it can monitor its lamp output for open or short circuits. No manufacturer document available to us uses P0623, so the description follows the principle of other lamp outputs. Under CARB a pure indicator lamp needs the check engine light only if other diagnostics depend on it, which is rarely the case. The lamp then never lights (not even at the bulb check) or stays on, and real charging faults may go unnoticed. The L line itself is P0621; the fuel cap lamp P0624 belongs to a different system.
Possible causes
- Wire or connector to the lamp or instrument cluster high
- Bulb/LED or instrument cluster faulty medium
- Output driver in the module low
- Ground fault low
Symptoms
- Battery lamp never lights (not even at bulb check) or stays on
- Real charging faults may not be displayed
- Otherwise usually no driving symptoms
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0623
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.