OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0620

Generator Control Circuit

The alternator regulator is linked to the engine module by an L (turn-on) line, an F (field) line reporting field load as a duty cycle, or on newer cars a LIN bus. P0620 is the general control circuit code. On LIN alternators it stands for disturbed control or communication: a manufacturer table published via NHTSA (gateway module with LIN alternator) lists it with the battery lamp on and stop-start disabled, alongside P065B for range/performance. Saab's 9-3 diesel uses it for the L line – open between module and alternator for more than 6 s, or a charging signal in an implausible state. Ford's 6.8 L V10 reports it with or without the check engine light depending on the variant. GM does not use P0620 and reports L and F line faults as P0621/P0622.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 20

Possible causes

  • Connector or wire between module and alternator (corrosion, break, chafing) high
  • Alternator or regulator faulty, including its LIN interface high
  • Battery flat or faulty, jump start or charger connected medium
  • Loose or worn drive belt low
  • Engine module or gateway (software, driver) low

Symptoms

  • Battery warning lamp on
  • Battery not or incorrectly charged, starting problems
  • Stop-start not working
  • Sometimes no noticeable symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0620

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication