OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P061F

Internal Control Module Throttle Actuator Controller Performance

P061F monitors the throttle position controller inside the engine module and its communication with the main processor. At Ford the main processor sends the target throttle angle to this controller (generation 2: a 312.5 Hz duty cycle signal, 10–92 % for 0–82°), which drives the throttle motor via an H-bridge; the monitoring checks that the target is implemented and reported back correctly. Ford 2012 sets it within 1 s – with the check engine light on generation 2 (2003–2007, separate controller chip), without it on generations 3/4 where the controller is integrated. A fault puts the throttle into its default position with an RPM limit. Ford 2020–23 no longer uses P061F (throttle controller faults run under P2107 ff). No other manufacturer document available to us uses it. Throttle motor circuit and function codes are P2100–P2112.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 1F

Possible causes

  • Internal fault in the throttle controller of the engine module medium
  • Throttle stiff, sooted or iced, controller at its limit medium
  • Engine module software or calibration fault (update available) medium
  • Throttle motor connector or wiring resistance low
  • Voltage dips, poor ground or supply at the module low

Symptoms

  • Wrench lamp (Ford), check engine light on generation 2
  • Throttle in default position, raised idle, barely any response
  • RPM limit

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P061F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication