P061E
Internal Control Module Brake Signal Performance
Electronic throttle systems run a second, independent calculation on the same processor (level 2, at Ford 'IPC – independent plausibility check') that recomputes driver demand, permitted and actual torque and their inputs, and compares them with the main software. Torque monitoring needs a reliable brake signal: brake applied means zero driver demand, cruise is cancelled, and in pedal limp mode the engine returns to idle. Ford introduced a brake switch with two outputs for this. P061E means the brake information is implausible inside the module – main software and monitoring do not see the same state, or the redundant brake data from the ABS module is invalid. Ford petrol engines set it within 1 s with the wrench lamp but no check engine light; from model year 2018 Ford replaced it with U1012. Ram 6.7 L Cummins (2019) fixed it by reprogramming. Brake switch circuit faults are P0571–P0573 and P0504.
Possible causes
- Brake light switch misadjusted or faulty (both outputs do not switch together) medium
- Engine module software or calibration fault (update available) high
- Faulty brake data from the ABS module or CAN disturbance medium
- Connector or wiring fault at the brake switch low
- Internal defect of the engine module low
Symptoms
- Wrench lamp (Ford), no check engine light
- Cruise control not working
- Possibly reduced power
- Stop-start possibly blocked
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P061E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.