OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P061C

Internal Control Module Engine RPM Performance

Electronic throttle systems run a second, independent calculation on the same processor (level 2, at Ford 'IPC – independent plausibility check') that recomputes driver demand, permitted and actual torque and their inputs, and compares them with the main software. P061C means the two internal engine speed calculations from the crankshaft signal disagree. GM's 6.6 L Duramax sets it at 400 rpm or more difference once the redundant speed is at least 600 rpm and the engine is synchronised, after 0.32 s, with the lamp after two trips; Ford's diesel also uses 400 rpm (5 s), Ford petrol engines react within 1 s with the check engine light. Because speed is a base value of torque monitoring, limp mode follows. A disturbed crankshaft signal can make both paths react differently, so fix P0335–P0339 first.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 1C

Possible causes

  • Engine module software or calibration fault (update available) high
  • Disturbed crankshaft signal (sensor, reluctor, shielding, connector, interference) medium
  • Voltage dips, poor ground or supply at the module medium
  • Internal defect of the engine module low

Symptoms

  • Check engine, wrench or service lamp
  • Reduced power or RPM limit
  • Stumbling or brief misfires with a disturbed signal
  • Rarely stalling

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P061C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication