OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P061A

Internal Control Module Torque Performance

Electronic throttle systems run a second, independent calculation on the same processor (level 2, at Ford 'IPC – independent plausibility check') that recomputes driver demand, permitted and actual torque and their inputs, and compares them with the main software. P061A is the result of the torque comparison: the commanded or estimated torque exceeds the permitted torque for the current operating point (Ford diesel 2023: within 0.1 s). The module reacts at once by limiting torque – RPM guard, pedal-follower mode, in severe cases engine shutdown. Ford petrol engines report it without the check engine light (CARB allows that for emission-neutral reactions), GM Europe as type C; GM North America does not use the code. Ram 6.7 L Cummins (2019) fixed it by reprogramming. Fix input sensor codes first, then check supply and ground, then look for a software update.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 1A

Possible causes

  • Engine module software or calibration fault (update available) high
  • Contradictory inputs (pedal, throttle, air mass, cruise request) produce an implausible torque demand medium
  • Voltage dips, poor ground or supply at the module medium
  • Internal defect of the engine module low
  • Unapproved power upgrade (torque model no longer fits) low

Symptoms

  • Reduced power or limp mode, poor throttle response
  • Wrench, service or check engine lamp depending on the maker
  • Cruise control disabled
  • Rarely the engine shuts off

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P061A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication