OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0615

Starter Relay A Circuit

The engine module switches the starter relay coil through its own driver – GM petrol engines with 12 V stop-start use a low-side driver, the Saab 9-4X switches 12 V to the coil. CARB requires output components to be checked for open and short circuits. GM sets the codes after two trips on stop-start engines, while GM diesels (2016) and the Saab 9-4X store them without the check engine light. At Ford an active starter code blocks stop-start. P0615 is the open or general circuit fault: GM measures the driver output with the driver off and sets the code at 200 kΩ or more after 40 of 50 samples at 50 ms. Chrysler traced no-start cases with P0615 to a harness chafed or pinched at the engine mount near the starter. Short to ground and to voltage are P0616 and P0617; the start request input is P0512.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 15

Possible causes

  • Starter relay faulty (coil open) high
  • Control wire open, harness chafed or pinched, connector corroded medium
  • Relay ground, fuse or supply faulty medium
  • Driver in the engine module faulty low

Symptoms

  • Engine does not crank
  • Stop-start not working
  • Intermittent starting problems
  • Check engine light only with some makers

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0615

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication