P0614
ECM/TCM Incompatible
P0614 means the software or calibration variant of the engine module does not match the fitted transmission module or transmission type, or the transmission module is not registered. CARB allows modules with several calibration variants (for example manual and automatic) to share one calibration ID only if a wrong variant turns on the lamp – exactly this check. GM's V6 engines (Saab 9-5 2010) run it continuously with ignition on and light the lamp in the first trip, also for incomplete programming; Saab's Bosch ME9 sets it when a wrong variant is programmed, without any other system reaction. Typical cases are a used module from a car with a different gearbox or a software update applied to only one of the two modules.
Possible causes
- Engine or transmission module replaced and not matched or registered high
- Used module with the wrong variant (different gearbox or engine) medium
- Software update on only one of the two modules medium
- Internal engine module fault low
Symptoms
- Check engine light on
- Possibly transmission limp mode or limited shifting
- Sometimes no other symptoms
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0614
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0602-p0606-p0610-p0614-p0630-p06d1-p160d-p160e-p161c-or-p2610-ecm-lau-lbw
- saabwisonline.com/9-3-9440/2006/dtcs/me9/p0614-00