OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0612

Fuel Injector Control Module Relay Control

Some diesels have a separate injector driver module that is powered through a relay switched by the engine module – GM's 6.6 L Duramax LB7/LLY with its injector driver unit, Ford's 6.0 L Power Stroke with its injector control module. P0612 means the commanded relay state and the voltage measured back at the output do not match. GM checks this with ignition on and the CAN link initialised, outside the shutdown phase, and sets the code after 30 of 50 checks at 125 ms; the lamp follows after two trips. If the relay fails, the injector module gets no power – the engine does not start or stalls; if it does not drop out, the module stays powered and drains the battery. Newer diesels have the injector drivers inside the engine module and use P062D/P062E instead. A fault reported by the injector module itself is P0611.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 12

Possible causes

  • Injector module relay faulty (coil open, contacts welded) high
  • Relay control or feedback wire open or corroded, fuse medium
  • Low battery voltage or ground problems medium
  • Driver in the engine module faulty low

Symptoms

  • Engine does not start or stalls while driving
  • Check engine light (GM after two trips)
  • Battery drain if the relay does not drop out
  • Often together with P0611 or injector codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0612

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication