OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P060B

Internal Control Module A/D Processing Performance

The analog-to-digital converter turns every analog sensor voltage into a number, so a faulty converter can falsify many values at once. The module checks it by timing its start-up calibration (GM 6.6 L diesel: 0.30 s or longer is a fault), by converting fixed internal reference voltages (about 4.73–4.83 V must be read), by grounding a test channel that must then read near 0 V (Ford diesel: over 249 mV is a fault) and by comparing with a second converter. GM sets it in the first trip, Ford with the check engine and wrench lamps as a level 3 check; the module usually enters limp mode. Ford fixed an F-150 2.7 L case (with misfire codes) by reprogramming. GM also uses P060B in the brake module – then ABS warnings appear and the engine module is not the culprit. The old wording 'A and D' simply spelled out 'A/D'.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 0B

Possible causes

  • Faulty module software (update available) high
  • Unstable supply voltage or poor ground at the module (weak battery, voltage spikes) medium
  • Internal defect of the converter or its chip medium
  • Shorted sensor input pulling the converter reference low

Symptoms

  • Check engine light, at Ford also the wrench lamp
  • Reduced power or limp mode
  • Several sensor or misfire codes at the same time
  • ABS/ESC warning if the brake module set the code

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P060B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication