OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0608

Control Module VSS Output A

Many engine or powertrain modules turn the raw wheel or output-shaft speed into a cleaned-up vehicle speed signal and pass it on through their own driver – a square-wave signal whose frequency rises with speed – to the instrument cluster, cruise control, radio or steering. P0608 concerns output A: the module compares the commanded driver state with the actual line state and reports a short to ground or voltage, an open circuit or an internal driver fault, as CARB requires for output components. Output A is the first such output, usually the speedometer feed. If the speed sensor itself fails, P0500–P0503 set instead. No manufacturer table available to us gives thresholds; GM lists the code in older vehicles. On modern cars speed is shared over CAN, so the code mainly affects older vehicles with a hard-wired speedometer signal.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 08

Possible causes

  • Short or open in the output line A to the receiving module high
  • Corroded or spread connector pins at the module or receiver medium
  • Faulty receiving module pulling the line to ground medium
  • Internal driver fault in the module low

Symptoms

  • Speedometer dead or jumping
  • Cruise control not working
  • Odometer stops counting
  • Speed-dependent functions (steering, radio volume) disturbed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0608

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication