OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0602

Control Module Programming Error

P0602 reports that the module is not, or not completely, programmed for this vehicle. GM checks at power-up and then every second whether a service replacement module still carries no calibration, and sets the code in the first trip; in brake modules a missing calibration set or a sensor ID that does not match also counts. Ford uses P0602 when the checksum of the vehicle identification block (tyre size, axle ratio, VIN) is wrong. Typical triggers are a new module that was never programmed, a reflash interrupted by a voltage dip or lost connection, or wrong software. Depending on the maker the engine may not start, run with reduced power or only show the lamp; GM Europe engines show a service lamp instead of the check engine light. The fix is almost always reprogramming with a stable power supply; replace the module only if the code returns.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 02

Possible causes

  • Module replaced and not (completely) programmed high
  • Programming interrupted by a voltage dip or lost connection high
  • Wrong or incompatible software, calibration or configuration block medium
  • Internal memory defect in the module low

Symptoms

  • Check engine light or service lamp
  • Engine may not start or runs in limp mode
  • Reduced engine power
  • Appears right after a module replacement or software update

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0602

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication