OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0601

Internal Control Module Memory Checksum Error

The module continuously calculates a checksum over its program and calibration memory (flash) and compares it with the stored value; on newer units the flash error correction also reports bit errors it cannot repair. A mismatch means the stored software is corrupted. GM sets P0601 in the engine module after one failed pass (or five once the first pass is complete) and turns on the lamp in the first trip; in body modules after two trips. Ford reports the same check as P0605, while GM, VW and Mazda use P0601. Typical causes are an interrupted reflash and manufacturer software errors – VW (2.0 TFSI) and Mazda (MX-5 2013) fixed it by reprogramming. The code alone does not say which module set it – the scan tool shows whether it is the engine, transmission, brake or body module.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / 01

Possible causes

  • Interrupted or faulty reprogramming high
  • Faulty module software (update available) medium
  • Defective flash memory in the module medium
  • Low voltage, voltage dips or a poor ground or supply at the module low

Symptoms

  • Check engine light on
  • Often no change in driving
  • Possibly no start or limp mode if the software is badly damaged
  • Transmission limp mode if the transmission module is affected

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0601

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication