P05FF
Brake Pressure Sensor/Brake Pedal Position Sensor Correlation
Stop-start decides when to stop and restart the engine from the brake: Ford stops it when the pedal switch is on and master cylinder pressure is high enough, and restarts when pressure falls below a filtered reference. P05FF means brake pressure (from the sensor in the ABS unit, sent over the network) and brake pedal position do not agree – for example pedal pressed without pressure build-up, or pressure without pedal. Ford's 2020–23 petrol vehicles check this continuously in the section 'Brake Diagnostics for Stop-Start Dependability' and set the code within 1 s, without the check engine light; stop-start is blocked so the engine is not stopped or started unexpectedly. Ford gives no threshold for the deviation. GM monitors the pedal travel sensor under P057x instead. Brake switch disagreement is P0504.
Possible causes
- Brake pedal position sensor or switch misadjusted or faulty high
- Master cylinder pressure sensor in the ABS unit faulty medium
- Network communication or software between ABS module and engine module medium
- Air in the brake system or hydraulic fault (long pedal travel without pressure) low
Symptoms
- Stop-start disabled
- No check engine light at Ford, possibly wrench or service warning
- Possible related codes P0504 or brake pressure codes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P05FF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.