OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05FC

Cold Start Fuel Pressure Performance Bank 2

During a cold start, direct injection petrol engines usually raise rail pressure for finer atomisation with multiple injections while the catalyst heats up. P05FC monitors whether the actual rail pressure of bank 2 stays within the target window during this phase – only engines with separate rails and pressure sensors per bank (V or boxer engines with two high-pressure circuits) can set it. CARB lists fuel pressure as a cold start component that must respond measurably beyond what would happen without the strategy. No manufacturer document available to us uses P05FC; Ford checks the single-rail counterpart P053F and flags a fault when the share of cold start time inside the pressure window is 0.70 or less, and Kia replaced the engine module of the 2018 Stinger 2.0T for P053F with stumbling during warm-up. GM uses P2C1E–P2C20 instead.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / FC

Possible causes

  • High-pressure pump or volume control valve of bank 2 weak or sticking high
  • Low supply pressure (low-pressure pump, filter) medium
  • Rail pressure sensor of bank 2 inaccurate medium
  • Engine module software medium
  • Leaking injector or pressure relief on bank 2 low

Symptoms

  • Check engine light on
  • Stumbling, hesitation or rough idle during warm-up
  • Poorer cold start
  • Usually normal once warm

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P05FC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication