P05FA
Stop-Start Status Signal Circuit Low
A discrete stop-start status line tells the engine module (or another module) whether stop-start is active, inhibited or has just stopped the engine. On most current cars this status travels over CAN instead, so a hard-wired line and these codes are rare; no manufacturer document available to us uses P05F9–P05FB. CARB names stop-start as its example of an 'emissions neutral' reaction: a module that simply disables stop-start when a fault appears may report it without the check engine light, which is what Ford does for its stop-start codes. P05FA means the status line stays below its lower limit – a short to ground or a missing pull-up supply. Stop-start is then disabled.
Possible causes
- Status line shorted to ground high
- Sending module pulls the line to ground permanently (faulty output) medium
- Moisture or corrosion in the connector low
Symptoms
- Stop-start does not work
- Stop-start indicator or message in the cluster
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P05FA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.