P05F7
Exhaust Aftertreatment Power Relay Control Circuit Stuck Off
A power relay, switched by the engine module through an output driver, feeds aftertreatment consumers such as the DEF pump, tank and line heaters and possibly NOx sensors or the SCR module. CARB requires such outputs to be checked for circuit faults and function. P05F7 is the opposite function check: the relay does not close although it is commanded on, so the load side stays without voltage. No manufacturer document available to us uses this exact code; GM and Ford monitor the same function under their own codes. If the relay fails, heaters, pump and SCR control drop out and dosing stops.
Possible causes
- Relay contacts burnt or coil faulty, relay does not close high
- Fuse on the load side blown medium
- Corroded connector or relay socket medium
- Output driver in the engine module faulty low
Symptoms
- Check engine light on
- DEF/AdBlue warning, possibly countdown to no-restart
- Follow-up codes for heaters, pump or NOx sensor supply
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P05F7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.