P05F6
Exhaust Aftertreatment Power Relay Control Circuit Stuck On
A power relay, switched by the engine module through an output driver, feeds aftertreatment consumers such as the DEF pump, tank and line heaters and possibly NOx sensors or the SCR module. CARB requires such outputs to be checked for circuit faults and function. P05F6 is a function check on the load side: the relay stays closed although it is switched off, so the consumers keep their supply, e.g. during after-run. A patent by Delphi describes this kind of check via the voltage at the heater node. No manufacturer document available to us uses this exact code; GM and Ford monitor the same function under their own codes. If the relay fails, heaters, pump and SCR control drop out and dosing stops.
Possible causes
- Relay contacts welded or sticking high
- External voltage on the load side (short to positive) medium
- Corroded connector or relay socket medium
- Output driver in the engine module faulty low
Symptoms
- Check engine light on
- DEF/AdBlue warning, possibly countdown to no-restart
- Follow-up codes for heaters, pump or NOx sensor supply
- Consumers stay powered after switch-off, battery drains
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P05F6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.