OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05EA

Engine Oil Bypass Valve Control Circuit High

The engine oil bypass valve is an electrically switched solenoid that, according to patents (Hyundai/Kia), routes oil around the oil cooler when cold so the engine warms up faster with less friction, and through the cooler once the oil is hot. It is not the purely mechanical oil filter bypass. CARB requires output components to be checked for circuit faults. No manufacturer document available to us uses P05E8–P05EA, and no vehicle with these codes was found. If the circuit fails, the valve stays in its unpowered position – depending on design oil may run too hot under load or warm up slowly. P05EA means the control circuit voltage is too high – a short to battery or overcurrent at the driver, so the valve cannot be operated.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / EA

Possible causes

  • Control wire touching battery or ignition voltage high
  • Valve coil shorted (overcurrent at the driver) medium
  • Connector or wiring damage medium
  • Control module low

Symptoms

  • Check engine light (if rated as emission related)
  • Oil too hot under load or slow warm-up, depending on rest position
  • Usually no noticeable driving symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P05EA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication