P05E8
Engine Oil Bypass Valve Control Circuit/Open
The engine oil bypass valve is an electrically switched solenoid that, according to patents (Hyundai/Kia), routes oil around the oil cooler when cold so the engine warms up faster with less friction, and through the cooler once the oil is hot. It is not the purely mechanical oil filter bypass. CARB requires output components to be checked for circuit faults. No manufacturer document available to us uses P05E8–P05EA, and no vehicle with these codes was found. If the circuit fails, the valve stays in its unpowered position – depending on design oil may run too hot under load or warm up slowly. P05E8 means the control circuit is open: the driver sees missing voltage or high resistance.
Possible causes
- Connector at the valve loose, corroded or spread high
- Valve solenoid coil open medium
- Broken wire in the harness medium
- Output driver in the module faulty low
Symptoms
- Check engine light (if rated as emission related)
- Oil too hot under load or slow warm-up, depending on rest position
- Usually no noticeable driving symptoms
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P05E8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.