P05E3
Park Brake Sensor/Switch Circuit
The engine module reads the park brake status, directly or via another module, because strategies depend on it: a parked diesel filter regeneration only runs with the park brake applied (Navistar), idle shutdown and PTO logic use it, and Ford delays an automatic restart while the electric park brake moves. CARB requires such inputs to be monitored. The only documented user of this code family is Volvo Trucks: since OBD 2021 a second park brake sensor (about 0.5 V applied, 3.5 V released) must agree with the old switch; the engine module reports the fault. No passenger car maker uses it verifiably. P05E3 is the general circuit fault – usually an open circuit or undefined state. Low and high signals are P05E4 and P05E5.
Possible causes
- Broken wire or corroded connector at the park brake switch or sensor high
- Switch or pressure sensor faulty medium
- Faulty diode in the switch circuit (Volvo) low
- Vehicle or brake module delivers a wrong status low
Symptoms
- Check engine light or OBD warning (heavy-duty)
- Park brake warning in the cluster
- Parked regeneration cannot be started
- Stop-start or idle shutdown not working
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P05E3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.