OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05E1

A/C Refrigerant Pressure Sensor A Circuit Intermittent/Erratic

The refrigerant pressure sensor (three wires, 5 V reference, signal rising with pressure) tells the engine module the A/C pressure; it uses it to switch the radiator fan, to block the compressor at too high or too low pressure and to pre-control idle load. CARB requires such inputs to be checked for circuit faults and plausibility, but they need not light the lamp if they do not affect emissions. 'Intermittent/Erratic' means the signal jumps implausibly fast or briefly leaves its valid range without staying low or high long enough for those codes. Sensor A is usually the high-pressure sensor; GM and Saab report it only as P0532/P0533 (circuit low/high, at GM below 3 % or above 98 % of 5 V) and P0531, so no manufacturer document available to us uses P05E1 itself. Typically the compressor is blocked and the fan runs. GM rates sensor A faults without the lamp, the Saab 9-4X with it.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / E1

Possible causes

  • Loose contact or corrosion at the sensor connector (front end, splash water) high
  • Chafed or broken wire (5 V, signal, ground) medium
  • Sensor faulty internally (signal jumps) medium
  • Shared 5 V reference disturbed by another sensor low

Symptoms

  • A/C intermittently not cooling (compressor switched off)
  • Radiator fan runs unnecessarily or irregularly
  • Idle speed fluctuates when A/C engages
  • Warning lamp depending on the maker

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P05E1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication