P05DB
Brake Pedal Position Sensor B Circuit/Open
Brake-by-wire and hybrid systems use a dual-channel pedal travel sensor; channel B runs opposite to A at Toyota (3.6–4.4 V at rest, falling when pressed), so a common fault of both channels shows up. It feeds brake assist and regenerative blending; CARB requires inputs used by other diagnoses to be monitored. A channel fault blocks the A/B correlation P05E0 and usually limits brake assist or regeneration. P05DB is the general circuit or open-circuit fault of channel B. Toyota's electronically controlled brake (RAV4 Hybrid 2024–25) reports channel B faults under it; while it is stored, the A/B correlation does not run.
Possible causes
- Harness or connector at the pedal sensor (open, contact fault) high
- Pedal sensor assembly faulty medium
- Retrofitted wiring near the pedal (e.g. trailer brake controller) low
- Brake or hybrid module low
Symptoms
- Brake or regeneration warning light
- Check engine light
- Regeneration or brake assist reduced, pedal feel changed
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P05DB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.