P05D3
Driver Mode Select Switch A Range/Performance
The driver mode select switch (tour, sport, eco, snow, off-road, towing) changes engine and transmission maps such as shift points, pedal map and cylinder deactivation, so CARB requires it to be monitored as an input. GM reads switch A as an eight-position resistor ladder in the body module and sets P05D1–P05D3 in its 2025 tables when a condition is present for 4 s within 5 s, type B with warning lamp after two trips. A fault blocks mode selection; the vehicle stays in its basic mode. P05D3 means the voltage lies between the low and high limits but in a dead band between two valid positions, so no position is clear – at GM for example 1.327–1.427 V or 2.967–3.348 V (petrol) and 0.528–0.628 V (diesel). Typical are contact resistance shifting all steps or a rotary switch resting between two detents.
Possible causes
- Corroded connector or increased contact resistance high
- Switch worn or detent unclear (knob between two positions) medium
- Moisture in the switch medium
- Ground offset at the switch low
Symptoms
- Selected mode not taken over or jumping
- Check engine light (GM after two trips)
- Mode display missing
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P05D3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.