P05D2
Driver Mode Select Switch A Circuit High
The driver mode select switch (tour, sport, eco, snow, off-road, towing) changes engine and transmission maps such as shift points, pedal map and cylinder deactivation, so CARB requires it to be monitored as an input. GM reads switch A as an eight-position resistor ladder in the body module and sets P05D1–P05D3 in its 2025 tables when a condition is present for 4 s within 5 s, type B with warning lamp after two trips. A fault blocks mode selection; the vehicle stays in its basic mode. P05D2 means the signal is above the highest valid window: GM petrol above 4.36 V, diesel above about 4.72 V. With a pull-up this usually means an open signal or switch ground, otherwise a short to positive.
Possible causes
- Signal or ground line open, connector off at the switch high
- Switch faulty (track interrupted) medium
- Signal line shorted to positive low
- Body module low
Symptoms
- Drive mode cannot be changed, vehicle stays in normal mode
- Mode display missing or jumping back
- Check engine light (GM after two trips)
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P05D2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.