P05CD
Cold Start A Camshaft Position Timing Performance Bank 2
During catalyst heating after a cold start the engine module commands a specific cam phaser position for more residual gas and exhaust heat; CARB requires this to be monitored under codes separate from the normal cam codes. These 'performance' codes are GM's current form (since about 2015/16; older GM engines and Ford use the direction codes P052A ff and P054A ff): fault when commanded and actual position differ by more than 4° or 6° once the target is stable. P05CD watches intake camshaft A on bank 2 of a V engine – the cold-start counterpart of P0021. GM's 3.0 L twin turbo sets it above 4° in 150 of 200 samples, type B, two trips; GM states it is the same type of diagnosis as P0021.
Possible causes
- Insufficient cold oil supply: wrong viscosity, low level, worn oil high
- Oil control valve bank 2 sticking or screen clogged medium
- Phaser worn or lock pin not releasing; on electric phasers a damaged phaser motor medium
- Timing chain stretched or skipped low
- Engine module software low
Symptoms
- Check engine light on (GM mostly after two trips)
- Often no noticeable symptoms, possibly rough cold idle
- Higher cold-start emissions
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P05CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.