OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05CC

Cold Start A Camshaft Position Timing Performance Bank 1

During catalyst heating after a cold start the engine module commands a specific cam phaser position for more residual gas and exhaust heat; CARB requires this to be monitored under codes separate from the normal cam codes. These 'performance' codes are GM's current form (since about 2015/16; older GM engines and Ford use the direction codes P052A ff and P054A ff): fault when commanded and actual position differ by more than 4° or 6° once the target is stable. P05CC watches intake camshaft A on bank 1 – the cold-start counterpart of P0011. GM's 3.0 L twin turbo sets it above 4°, 60 of 100 samples, type B; the 2.0 L turbo in the Envision above 6° as type A after one trip. A GM bulletin for the 2024–25 Traverse, Enclave and Acadia (2.5 L turbo, electric phaser) names a damaged phaser motor with rattle, together with P0011/P0016.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / CC

Possible causes

  • Insufficient cold oil supply: wrong viscosity, low level, worn oil high
  • Oil control valve sticking or screen clogged medium
  • Phaser worn or lock pin not releasing; on electric phasers a damaged phaser motor medium
  • Timing chain stretched or skipped low
  • Engine module software low

Symptoms

  • Check engine light on (GM mostly after two trips)
  • Often no noticeable symptoms, possibly rough cold idle
  • Rattle from the timing drive (GM electric phaser)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P05CC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication