P05C0
Active Grille Air Shutter Module A Over Temperature
Shutters cut drag and speed warm-up when closed and open for cooling; CARB names them as an off-cycle CO2 technology and treats the actuator as an output component. Smart actuators report over LIN (loss of communication: U0285); a fault usually costs fuel and warm-up time, a closed shutter can make the engine run hot under load. P05C0 means the smart actuator of shutter A (the upper one) measures its control chip above 140 °C for 10 s and switches its driver off for protection. Documented only for Ford's 3.0 L diesel. Usual causes are continuous motor load from a stiff or blocked shutter or a shorted coil, or an internal fault; it may work again after cooling.
Possible causes
- Actuator faulty internally (driver overheating) high
- Shutter stiff or blocked (ice, dirt, bent louvres) causing continuous current medium
- High heat load at the mounting point (radiator, traffic, towing) low
Symptoms
- Shutter inoperative at times
- Check engine light possible
- Possibly also a performance code
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P05C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.