P05BA
Restraint Deployment Signal Circuit High
After a crash the restraint control module tells the engine module that airbags or belt tensioners have fired; the engine module then cuts the fuel pump (Ford: until the ignition is cycled) and possibly the engine. Depending on the maker the message travels over CAN and/or a dedicated wire with a defined level or voltage drop. P05BA means the signal line stays above its valid range – a short to battery or ignition voltage, or with a pull-up in the engine module an open circuit. The fuel cut-off may then not work via this line. No manufacturer document available to us uses this code; it is a safety function, not an emission-relevant monitor, so usually without warning lamp.
Possible causes
- Signal wire shorted to battery or ignition voltage high
- Open circuit with pull-up in the engine module medium
- Retrofitted loads or harness damage after accident repair medium
- Restraint or engine module low
Symptoms
- Code stored
- Vehicle drives normally
- No check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P05BA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.