P05B8
Restraint Deployment Signal Circuit/Open
After a crash the restraint control module tells the engine module that airbags or belt tensioners have fired; the engine module then cuts the fuel pump (Ford: until the ignition is cycled) and possibly the engine. Depending on the maker the message travels over CAN and/or a dedicated wire with a defined level or voltage drop. P05B8 means the wired signal line is open – no valid rest level arrives. After a real crash the fuel cut-off may then not be triggered via this line. No manufacturer document available to us uses this code; it is a safety function, not an emission-relevant monitor, so usually without warning lamp.
Possible causes
- Signal wire or connector between restraint and engine module open (e.g. after accident repair or seat removal) high
- Corroded or spread pin at either module medium
- Replacement module not configured medium
- Restraint module output stage low
Symptoms
- Code stored, driving usually normal
- Possibly message that fuel cut-off is unavailable
- No check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P05B8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.