OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05B3

Active Grille Air Shutter B Control Circuit High

Shutter B is the second active grille shutter – at GM, Ford and Stellantis the lower one in the bumper. Shutters cut drag and speed warm-up when closed and open for cooling; CARB names them as an off-cycle CO2 technology and treats the actuator as an output component. Smart actuators report over LIN (loss of communication: U0285); a fault usually costs fuel and warm-up time, a closed shutter can make the engine run hot under load. P05B3 means the control circuit voltage of actuator B is too high – a control line shorted to positive or a driver unable to pull it to ground. In this family high comes before low. No manufacturer document available to us uses this code, like its shutter A counterpart. Ford reports coil shorts under P05B1, Toyota as P05B1 with failure type 12.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / B3

Possible causes

  • Actuator B faulty internally high
  • Control line shorted to positive (front harness) medium
  • Water or corrosion in the connector medium
  • Module driver low

Symptoms

  • Check engine light on
  • Lower shutter inoperative
  • Slightly higher consumption, longer warm-up

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P05B3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication