OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05B1

Active Grille Air Shutter B Control Circuit/Open

Shutter B is the second active grille shutter – at GM, Ford and Stellantis the lower one in the bumper. Shutters cut drag and speed warm-up when closed and open for cooling; CARB names them as an off-cycle CO2 technology and treats the actuator as an output component. Smart actuators report over LIN (loss of communication: U0285); a fault usually costs fuel and warm-up time, a closed shutter can make the engine run hot under load. P05B1 concerns the control or motor coil circuit of actuator B. Ford's 3.0 L diesel reports an open and a shorted coil under it, checked at the start and 500 ms after each movement, fault after 10 s. Toyota's RAV4 Hybrid uses P05B1 as a collective code with failure types for short to positive, short to ground or open, and no signal. GM does not use it.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / B1

Possible causes

  • Actuator B coil open or shorted high
  • Connector corroded or damaged (lower bumper, splash water) medium
  • Front harness damaged (impact, chafing, rodents) medium
  • Module low

Symptoms

  • Check engine light on
  • Lower shutter inoperative
  • Slightly higher consumption, longer warm-up

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P05B1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication