OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05B0

Active Grille Air Shutter B Position Sensor Minimum/Maximum Stop Performance

Shutter B is the second active grille shutter – at GM, Ford and Stellantis the lower one in the bumper. Shutters cut drag and speed warm-up when closed and open for cooling; CARB names them as an off-cycle CO2 technology and treats the actuator as an output component. Smart actuators report over LIN (loss of communication: U0285); a fault usually costs fuel and warm-up time, a closed shutter can make the engine run hot under load. P05B0 checks whether shutter B reaches its end stops, the reference for position feedback in the self-learning run. Ford's 3.0 L diesel sets it at over 40° when learning closed, 20° when learning open or 20° in operation, after 10 s. Ford's petrol F-150 of 2024–25 uses it too: a Ford service message says to fit a new lower shutter before further diagnosis.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / B0

Possible causes

  • Lower shutter or actuator faulty high
  • Louvres blocked or bent (ice, stone chips, impact) medium
  • Shutter misassembled or connector off after repair medium
  • Connector or harness corroded low

Symptoms

  • Check engine light on
  • Lower shutter not moving fully
  • Possibly also P05AE

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P05B0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication