OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P05AF

Active Grille Air Shutter B Stuck On

Shutter B is the second active grille shutter – at GM, Ford and Stellantis the lower one in the bumper. Shutters cut drag and speed warm-up when closed and open for cooling; CARB names them as an off-cycle CO2 technology and treats the actuator as an output component. Smart actuators report over LIN (loss of communication: U0285); a fault usually costs fuel and warm-up time, a closed shutter can make the engine run hot under load. P05AF is the counterpart of P05AE: shutter B stuck open. Documented only in the VW group – Audi's 2022–24 A3, S3 and RS3 describe it internally as 'grille shutter 2 sticks open' and limit top speed to 100 mph on a shutter fault; the warning was sometimes set by engine module software. GM, Ford and Stellantis report everything under P05AE.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / AF

Possible causes

  • Engine module software (sporadic false message) high
  • Louvres blocked open (ice, dirt, debris, accident damage) medium
  • Actuator or shutter unit B faulty medium
  • Poor supply or ground at the actuator low

Symptoms

  • Check engine light on
  • Grille shutter warning, top speed limited (Audi)
  • Longer warm-up, slightly higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P05AF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication