P05A4
Active Grille Air Shutter A Control Circuit High
An active grille shutter closes louvres in the grille to cut drag and speed warm-up and opens them for cooling; CARB names it as an off-cycle CO2 technology and treats the actuator as an output component. Smart actuators (Ford 3.0 L diesel, Toyota) check their own coil and supply and report over LIN; simpler ones (VW 1.8 T) have their own supply and a control line from the engine module. GM uses none of P05A2–P05A8. A fault usually only costs fuel and warm-up time. P05A4 means the control circuit voltage is too high – a control line shorted to positive or a driver unable to pull it to ground. In this family high comes before low. No manufacturer document available to us uses this code. Ford reports coil shorts under P05A2, Toyota with a failure-type byte.
Possible causes
- Actuator motor faulty internally high
- Control line shorted to positive (front harness) medium
- Water or corrosion in the connector medium
- Engine module driver low
Symptoms
- Check engine light on
- Shutter not moving (usually open)
- Slightly higher consumption, longer warm-up
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P05A4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.