OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0598

Thermostat Heater Control Circuit Low

A map-controlled thermostat is a wax thermostat with a built-in heating resistor (Valeo: about 10 Ω). Unheated it opens late, for hot running at part load; the engine module heats it by map under full load or towing so it opens earlier. CARB requires the thermostat to be monitored and the heater circuit counts as an output component. GM switches it to ground with a low-side driver and checks it every second, fault after 15 of 30 samples, type B; Hyundai/Kia/Genesis and VW/Audi use the codes as well. P0598 means the control line is shorted to ground – GM detects 0.5 Ω with the driver off. With a low-side driver the heater then stays on permanently and the thermostat opens early, so the engine runs cool; Kia's Cadenza bulletins list it with P0128 and replace the thermostat.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 98

Possible causes

  • Internal short in thermostat or heater, coolant in the connector high
  • Control line shorted to ground (chafing) medium
  • Engine module driver low

Symptoms

  • Check engine light on
  • Engine slow to reach operating temperature (possibly P0128)
  • Weak cabin heating in winter, higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0598

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication