OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0597

Thermostat Heater Control Circuit/Open

A map-controlled thermostat is a wax thermostat with a built-in heating resistor (Valeo: about 10 Ω). Unheated it opens late, for hot running at part load; the engine module heats it by map under full load or towing so it opens earlier. CARB requires the thermostat to be monitored and the heater circuit counts as an output component. GM switches it to ground with a low-side driver and checks it every second, fault after 15 of 30 samples, type B; Hyundai/Kia/Genesis and VW/Audi use the codes as well. P0597 means the heater circuit is open – GM above 200 kΩ with the driver off. The thermostat then only works through its wax and opens late, so coolant runs hotter under load; Audi's 4.2 FSI also limits engine speed. Genesis (G80/G90 3.3 T, 3.8) replaced thermostats from an early production lot.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 97

Possible causes

  • Heating resistor in the thermostat open high
  • Connector at the thermostat loose or corroded, coolant in the connector medium
  • Broken wire or missing supply (fuse, relay) medium
  • Engine module driver low

Symptoms

  • Check engine light on (after two trips)
  • Coolant temperature higher than usual under load
  • Audi/VW: coolant warning and engine speed limit possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0597

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication