P0593
Cruise Control Multi-Function Input B Circuit High
Cruise control buttons form a resistor ladder on one or two signal lines, each button giving its own voltage window. FCA uses two lines with offset windows – signal 1 is input A, signal 2 input B – and both must report the same button; GM evaluates the ratio to the reference. Any fault locks out cruise control; CARB treats this as emission-neutral, and GM and Ford set these codes without warning lamp. P0593 means signal line B is too high: GM at a ratio of 1.005–1.035 for over 2 s (short to power), FCA above 4.706 V with about 4.54 V at rest. In FCA's Jeep Wrangler JK recalls it is a typical sign of a dusty clockspring.
Possible causes
- Clockspring dirty or faulty high
- Line B shorted to positive or ground open medium
- Button block or connector medium
- Module low
Symptoms
- Cruise control inoperative, possibly airbag warning (Jeep JK)
- Cruise control locked out
- No check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0593
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.