P0591
Cruise Control Multi-Function Input B Circuit Range/Performance
Cruise control buttons form a resistor ladder on one or two signal lines, each button giving its own voltage window. FCA uses two lines with offset windows – signal 1 is input A, signal 2 input B – and both must report the same button; GM evaluates the ratio to the reference. Any fault locks out cruise control; CARB treats this as emission-neutral, and GM and Ford set these codes without warning lamp. P0591 means signal 2 is outside its window while a button is pressed – for on/off FCA expects 0.900 V and sets the code above 0.980 V, active only while the button is held. Usual cause is oxidation at the six-pin steering wheel connector; in the Jeep Wrangler JK recalls it indicates a faulty clockspring. GM does not use P0591.
Possible causes
- Oxidised steering wheel connector at clockspring or column module high
- Clockspring dirty or faulty high
- Button block aged medium
- Column module or PCM low
Symptoms
- Cruise control working sporadically or not at all
- Cruise control locked out
- No check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0591
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.