OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P058F

Battery Monitor Module Temperature Too Low

The battery monitor module (intelligent battery sensor) sits on the negative terminal of the 12 V battery: a shunt measures current, electronics also measure voltage and temperature and calculate state of charge, health and cranking ability, reporting over LIN. Energy management uses the data for alternator control, idle boost and stop-start release, which is why the engine module diagnoses it. GM sets P058A–P058F in its engine modules from 2016 as type B, warning lamp after two trips. P058F means the module reports a temperature below its plausible range: GM sets it below −43 °C in 4 of 5 samples, but only with an outside temperature above −20 °C – so the value is physically implausible, usually an open sensing circuit or faulty sensor. It suspends P058C; the charge voltage then lacks correct temperature compensation.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 8F

Possible causes

  • Battery sensor faulty internally (temperature element open) high
  • Sensor software or initialisation after power loss low
  • Supply or connector problem at the sensor low

Symptoms

  • Check engine light on
  • Stop-start not available
  • No driveability problems

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P058F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication