OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P058A

Battery Monitor Module Performance

The battery monitor module (intelligent battery sensor) sits on the negative terminal of the 12 V battery: a shunt measures current, electronics also measure voltage and temperature and calculate state of charge, health and cranking ability, reporting over LIN. Energy management uses the data for alternator control, idle boost and stop-start release, which is why the engine module diagnoses it. GM sets P058A–P058F in its engine modules from 2016 as type B, warning lamp after two trips. P058A means the module reports an internal fault of its own over LIN. GM checks it every 250 ms above 9 V, without LIN faults and at outside temperatures of −20 to 50 °C. Battery data are then unreliable – stop-start is blocked and the alternator usually runs a fixed substitute voltage. Loss of communication is a separate U code.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 8A

Possible causes

  • Battery sensor faulty internally high
  • Poor supply or ground at the sensor (loose terminal, corroded connector) medium
  • Sensor not relearned after battery replacement or disconnection medium
  • Module or engine module software low

Symptoms

  • Check engine light on
  • Stop-start not available
  • No driveability problems

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P058A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication