P0584
Cruise Control Vacuum Control Circuit High
Older engines without electronic throttle use a vacuum cruise servo on the throttle cable: a vacuum valve (closed when unpowered) opens the throttle with intake vacuum, a vent valve (open when unpowered) holds or releases it, and a dump valve fed through the brake switch vents it when braking. Where the engine module drives these valves, it checks each circuit and switches cruise off; CARB treats this as emission-neutral, usually without warning lamp. P0584 means the voltage at the vacuum valve driver is too high – a control line shorted to positive or a valve drawing no current when commanded. No manufacturer document available to us uses this code.
Possible causes
- Vacuum control line shorted to positive high
- Servo or vacuum valve faulty internally medium
- Damp or corroded connector medium
- Engine module low
Symptoms
- Cruise control cannot be engaged or switches off
- Cruise indicator goes out or flashes (depending on vehicle)
- Usually no check engine light, code stored only
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0584
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.