P0581
Cruise Control Multi-Function Input A Circuit High
Cruise control buttons form a resistor ladder on one or two signal lines, each button giving its own voltage window. FCA uses two lines with offset windows – signal 1 is input A, signal 2 input B – and both must report the same button; GM evaluates the ratio to the reference. Any fault locks out cruise control; CARB treats this as emission-neutral, and GM and Ford set these codes without warning lamp. P0581 means signal line A is too high: GM at a ratio of 1.005–1.035 for over 2 s (short to power); FCA treats 4.706–5.0 V as circuit high. In FCA's recalls of the Jeep Wrangler JK (2007–2016), P0581 indicates a dusty clockspring, which is replaced. Ford lists it without warning lamp.
Possible causes
- Clockspring dirty or faulty high
- Signal line shorted to positive or ground open medium
- Button block faulty medium
- Corroded steering wheel connector medium
Symptoms
- Cruise control inoperative, on the Jeep JK possibly airbag warning
- Cruise control locked out
- No check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0581
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- static.nhtsa.gov/odi/rcl/2016/RCRIT-16V290-9641.pdf
- static.nhtsa.gov/odi/rcl/2016/RCRIT-16V288-5957.pdf
- roushcleantech.com/wp-content/uploads/sites/all/themes/roushcleantech/pdf/diagnosticmanuals/Roush_CleanTech _Diagnostics_Manual-DA_8.5.18.pdf