P0580
Cruise Control Multi-Function Input A Circuit Low
Cruise control buttons form a resistor ladder on one or two signal lines, each button giving its own voltage window. FCA uses two lines with offset windows – signal 1 is input A, signal 2 input B – and both must report the same button; GM evaluates the ratio to the reference. Any fault locks out cruise control; CARB treats this as emission-neutral, and GM and Ford set these codes without warning lamp. P0580 means signal line A is too low: GM at a ratio of 0–0.185 for over 2 s (short to ground or, depending on wiring, open circuit); FCA treats signal 1 below 0.216 V as circuit low. Work at the steering wheel involves the driver airbag.
Possible causes
- Signal line shorted to ground (steering wheel wiring, clockspring) high
- Button block faulty (water, dirt) medium
- Steering wheel or clockspring connector corroded or off medium
- Evaluating module low
Symptoms
- Cruise control cannot be switched on, indicator missing
- Cruise control locked out
- No check engine light
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0580
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.