P057E
Brake Pedal Position Sensor A Circuit Intermittent/Erratic
The brake pedal position sensor A is an analogue 5 V sensor giving pedal travel continuously; its rest position (about 1 V) is learned. GM reads it in the engine module from about 2012 and uses it as an enabling condition of transmission monitors – hence type A, warning lamp after one trip, unlike cruise control codes. On any circuit fault GM sets the pedal to 0 %, so brake detection relies on the brake light switch. P057E means implausibly fast signal jumps within the valid range: GM sets it at jumps above 11 in 5 of 20 samples. Brief interruptions can also make GM's engine module learn a wrong rest position – it then sees the brake pressed and cuts power; GM names fretting at the 5 V reference or signal.
Possible causes
- Loose contact or fretting corrosion at sensor or inline connector high
- Broken or chafed wire near the pedal medium
- Sensor worn internally (signal jumping) medium
- Interference on the 5 V reference low
Symptoms
- Check engine light on (GM)
- Sporadic power reduction when accelerating
- Cruise control cutting out sporadically
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P057E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.