OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P057D

Brake Pedal Position Sensor A Circuit High

The brake pedal position sensor A is an analogue 5 V sensor giving pedal travel continuously; its rest position (about 1 V) is learned. GM reads it in the engine module from about 2012 and uses it as an enabling condition of transmission monitors – hence type A, warning lamp after one trip, unlike cruise control codes. On any circuit fault GM sets the pedal to 0 %, so brake detection relies on the brake light switch. P057D means the signal is too high: GM above 95 in 20 of 32 samples and calls this explicitly an open circuit – an open signal or ground line is pulled up. A short to 5 V or battery acts the same. 'High' means signal, not a fully pressed pedal. GM bulletins name connector X205 on 2012–14 pick-ups.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 7D

Possible causes

  • Ground or signal line open, connector X205 with poor contact high
  • Sensor faulty medium
  • Signal shorted to voltage low
  • Sensor misinstalled or misadjusted low

Symptoms

  • Check engine light on (GM, one trip)
  • Cruise unavailable, brake light or stability messages
  • Possible power reduction

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P057D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication