P057C
Brake Pedal Position Sensor A Circuit Low
The brake pedal position sensor A is an analogue 5 V sensor giving pedal travel continuously; its rest position (about 1 V) is learned. GM reads it in the engine module from about 2012 and uses it as an enabling condition of transmission monitors – hence type A, warning lamp after one trip, unlike cruise control codes. On any circuit fault GM sets the pedal to 0 %, so brake detection relies on the brake light switch. P057C means the signal is too low – a short to ground: GM below 5 in 20 of 32 samples. GM bulletins for 2012–14 pick-ups and SUVs name connector X205 under the left defroster duct, with cruise, brake light and stability messages and reduced power.
Possible causes
- Connector or terminals at sensor or inline connector (GM X205) loose, pushed back or corroded high
- Signal or 5 V reference shorted to ground medium
- Sensor faulty internally medium
- 5 V reference pulled down by another sensor low
Symptoms
- Check engine light on (GM, one trip)
- Cruise control, brake light or stability functions restricted
- Reduced power when accelerating
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P057C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.