OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P057B

Brake Pedal Position Sensor A Circuit Range/Performance

The brake pedal position sensor is an analogue 5 V sensor, usually Hall-type, giving the pedal position continuously instead of a switch – for brake lights, cruise control, stop-start, brake-throttle override and regenerative braking. GM (from about 2012) and Stellantis read it in the engine module, Saab's 9-4X and 9-5 in the body module; its learned rest position (about 1 V) must be relearned after replacement. P057B means the signal is valid but the pedal does not move as expected or the rest position is wrong. GM rates pedal movement once per ignition cycle while driving at 8 km/h or more without throttle (fail below 0.40, pass above 0.80), type A, one trip. If the module sees the pedal slightly pressed, it cuts power – GM and Stellantis bulletins name misinstalled or wrongly learned sensors.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 7B

Possible causes

  • Sensor misinstalled or not learned after replacement high
  • Contact fault on 5 V reference or signal causes wrong rest position learning medium
  • Sensor faulty internally (sticking) medium
  • Pedal mechanism stiff, floor mat low

Symptoms

  • Check engine light on
  • Reduced power when accelerating
  • Cruise control and stop-start inoperative

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P057B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication