P057A
Brake Pedal Position Sensor A Circuit/Open
The brake pedal position sensor is an analogue 5 V sensor, usually Hall-type, giving the pedal position continuously instead of a switch – for brake lights, cruise control, stop-start, brake-throttle override and regenerative braking. GM (from about 2012) and Stellantis read it in the engine module, Saab's 9-4X and 9-5 in the body module; its learned rest position (about 1 V) must be relearned after replacement. P057A is the general circuit or open-circuit fault. No manufacturer document available to us uses it; GM reports an open circuit as P057C or P057D depending on the line, type A with one trip, and sets the pedal position to 0 %. Brake detection then relies on the brake light switch.
Possible causes
- Connector at the sensor loose or corroded, pins pushed back high
- 5 V reference, signal or ground line open medium
- Sensor faulty internally medium
- Engine or body module low
Symptoms
- Check engine light on
- Cruise control and stop-start inoperative
- Possible power reduction
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P057A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.