OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0579

Cruise Control Multi-Function Input A Circuit Range/Performance

Cruise control buttons are almost always a resistor ladder on one or two signal lines, each button giving its own voltage; the module reading it (GM and Saab from about 2010: the body module; FCA: steering column module or PCM) sends the button state to the engine module over CAN. CARB names cruise control as the example of an emission-neutral diagnosis – it is simply switched off – so GM lists all these codes as type C and Ford as non-MIL: no warning lamp, the engine runs normally. FCA uses two redundant lines with mirrored ladders: P0579 sets when signal 1 is outside its window while a button is pressed – for on/off it must lie between 0.235 and 0.353 V – and is active only while the button is held. Usual cause is oxidation at the six-pin steering wheel connector or the clockspring; the Jeep JK recall replaces the clockspring.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 79

Possible causes

  • Oxidised or dirty contacts at the steering wheel connector high
  • Switch contact for signal 1 not closing medium
  • Clockspring faulty medium
  • Wiring or module low

Symptoms

  • Cruise control cannot be switched on at times
  • Cruise control locked out
  • No check engine light, engine runs normally

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0579

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication